Cisco – MLS (QoS) on a switch

If you find alot of MLS entries in your running-config file you may have QoS enabled. Within the lab i dont require QoS (Quality of Service) to be enabled so have disabled it via this command (config t);

no mls qos

Note: this was a 2960G switch.

Remember to save running config to startup config. Done.

A good reference page here…

http://www.cisco.com/en/US/docs/switches/lan/catalyst2960/software/release/12.2_37_ey/configuration/guide/swqos.html#wp1021247

Leave a Reply

Your email address will not be published.