Cisco

Great article on setting up connection between HP & Cisco….

http://evilrouters.net/2011/08/12/configure-lacp-between-hp-procurve-and-cisco-catalyst-switches/

 

Want to propergate vLan information across multiple switches?

Easy in the Cisco world…  Just use VTP - configure a server switch and  your away… (it also has its risks if you introduce another server switch with a lower ID)

What does HP have?  – GVRP (MVRP newer iteration).

http://en.wikipedia.org/wiki/Multiple_Registration_Protocol

Multiple VLAN Registration Protocol (MVRP), which replaced GARP VLAN Registration Protocol (GVRP), is a standards-based Layer 2 network protocol, for automatic configuration of VLAN information on switches. It was defined in the 802.1ak amendment to 802.1Q-2005.

One of the best articles i have found on this subject is here : http://blog.scottlowe.org/2008/07/16/understanding-nic-utilization-in-vmware-esx/

There is some additional information here on setting up an etherchannel on the cisco side : http://blog.scottlowe.org/2006/12/04/esx-server-nic-teaming-and-vlan-trunking/

This can be handy if you need a single VM to use both physical nics in a load-balanced manner - both outbound and inbound. Of course its not really that simple though. This will really only add a benefit if the VM is communicating to multiple destinations (using ip hash - a single destination from a single VM with one IP will always be limited to the same physical nic).

To show what routes your cisco router currently has loaded type the following command (from the enable prompt) ;

show ip route

To add any new static routes you need to use the following command (from the config terminal prompt) ;

ip route 10.10.20.0 255.255.255.0 192.168.100.1

the syntax as above is ip route network netmask gateway

Telnet to your cisco router, enable then go into config t. Passwords may be required depending on how it has been configured…

en

config t

Ensure that ip routing has been enabled…

ip routing

To create the VLAN adapter you’ll need to run the following commands to create a “router on a stick”…   Note: the .2 after the interface name creates a virtual adapter on the interface.

interface FastEthernet1/1.2 description “VM Host Network” encapsulation dot1Q 2 ip address 172.25.2.1 255.255.255.0

Setting up a trunk between switches

Enable Switch to enable mode Configure Terminal Enter global configuration mode

Interface FastEthernet0/1 Entering interface configuration for port 0/1. This is where you pick the port you want to trunk.

Switchport mode trunk Set port to trunking mode.

Switchport trunk encapsulation dot1q Set trunk type to 802.1q. If your switch only supports either ISL or 802.1q, this command does not exist because there is nothing to specify. This command only works when you can choose between the two.