Config

Previously to take down this wordpress site all you needed to do was hold down F5 for about 20 seconds then the site would take about 5 mins to recover.

There were a few factors causing this and quite a few different methods to solving the problem. Wordpress itself is run on php / apache, apache has an evasive mod which can block certain IPs depending on the defined abusive behavior (typical DDOS attack). Since i like to run a few websites behind a single IP i looked at fixing the issue closer to the perimeter….

If you dont have the disks available to build up a zpool and have a play with zfs you can actually just use files created with the mkfile command… The commands are exactly the same.

mkfile 64m disk1

mkfile 64m disk2

mkfile 64m disk3

mkfile 10m disk4

mkfile 100m disk5

mkfile 100m disk6

Now you can create a zpool using the above files… (i’m using raidz for this setup)

zpool create test raidz /fullpath/disk1 /fullpath/disk2 /fullpath/disk3